![]() Once Freesat setup is complete, go to Setup, then Manual Tune. To set up your receiver for multi-satellite reception, a Freesat installation is first required.įreesat is the only group of satellites that are detected (DiSEqC C) during the first installation, the DiSEqC port will vary depending on which port it has been connected to. RED, GREEN, YELLOW, BLUE, GREEN, YELLOW, BLUE It is far easier to use a separate receiver that is intended for multi-satellite viewing.Ī Freesat Installation is required before the other satellites can be setup and configured.Īccessing the DiSEqC Menus, is via a secret menu, by pressing the colour buttons in the following sequence: RED, GREEN, YELLOW, BLUE, GREEN, YELLOW, BLUEĪccessing the DiSEqC Menus, is via a secret menu, by pressing the colour buttons in the following sequence: ![]() Remember, Freesat receivers are not intended for multi-satellite viewing, all channels, other than those listed on the Freesat EPG, can only be viewed in non-Freesat mode. Make sure the satellite receiver is connected to the various LNBs and satellite dishes, then turn on the device. This gives you the option to connect the receiver to more than one satellite. DiSEqC is available on some Freesat receivers and PVRs, such as the Humax FOXSAT-HD and FOXSAT-HDR receivers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |